Idea
In short
How do you build a greenhouse air controller?
A CO2 and humidity sensor runs a small fan when the air gets stale or damp, with a limit on run time. You need Arduino Nano, SCD40 CO2 sensor, 12 V DC fan 80 mm, MOSFET IRLZ44N, Rectifier Diode 1N4007, Resistor 10 kΩ, 12 V 2 A DC adapter, Fuse 1 A glass (5 × 20 mm) and Breadboard 830 Tie Points.
- Level
- Advanced
- Time
- About 300 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Control ventilation from two readings.
Parts list
- Development Boards
- Sensors
- Motors & Actuators
- Semiconductors
- Semiconductors
- Passives
- Power
- Passives
- Prototyping
How to build it
- Read CO2 and humidity
- Set the on and off levels
- Switch the fan through a MOSFET
- Limit the run time
- Log to the serial monitor
Common questions
What parts do I need for the greenhouse air controller?
Arduino Nano, SCD40 CO2 sensor, 12 V DC fan 80 mm, MOSFET IRLZ44N, Rectifier Diode 1N4007, Resistor 10 kΩ, 12 V 2 A DC adapter, Fuse 1 A glass (5 × 20 mm) and Breadboard 830 Tie Points.
How long does the greenhouse air controller take to build?
About 300 minutes for a advanced maker.
