Idea
In short
How do you build a grow light timer?
A 12 V LED strip over a pot is switched on a daily schedule by an RTC and MOSFET. You need Arduino Nano, DS3231 RTC module, MOSFET IRLZ44N, 12 V LED strip warm white (5 m, 2835), 12 V 2 A DC adapter, Resistor 10 kΩ, Resistor 220 Ω, Fuse 1 A glass (5 × 20 mm), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Run a timed schedule using a low-side MOSFET.
Parts list
- Development Boards
- Sensors
- Semiconductors
- Optoelectronics
- Power
- Passives
- Passives
- Passives
- Prototyping
- Prototyping
How to build it
- Set on and off times
- Switch the strip with a low-side MOSFET
- Add a flyback-free resistive-load check
- Fuse the 12 V line
- Show the schedule on a small display
Common questions
What parts do I need for the grow light timer?
Arduino Nano, DS3231 RTC module, MOSFET IRLZ44N, 12 V LED strip warm white (5 m, 2835), 12 V 2 A DC adapter, Resistor 10 kΩ, Resistor 220 Ω, Fuse 1 A glass (5 × 20 mm), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the grow light timer take to build?
About 180 minutes for a intermediate maker.
