Idea
In short
How do you build a mine worker safety helmet?
A helmet monitors gas and temperature and warns the worker, sending data to a base unit. You need ESP32 DevKit V1, MQ-7 carbon monoxide sensor module, SHT31 temperature and humidity sensor, LM35 temperature sensor, Active buzzer 5 V, Vibration motor (coin type) and Li-Po battery 3.7 V 2000 mAh.
- Level
- Intermediate
- Time
- About 300 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a wearable safety monitor.
Parts list
- Development Boards
- Sensors
- Sensors
- Sensors
- Motors & Actuators
- Motors & Actuators
- Batteries
How to build it
- Read CO and temperature
- Alarm above limits
- Send data by LoRa to the surface
- Add a panic button
- Check battery before each shift
Common questions
What parts do I need for the mine worker safety helmet?
ESP32 DevKit V1, MQ-7 carbon monoxide sensor module, SHT31 temperature and humidity sensor, LM35 temperature sensor, Active buzzer 5 V, Vibration motor (coin type) and Li-Po battery 3.7 V 2000 mAh.
How long does the mine worker safety helmet take to build?
About 300 minutes for a intermediate maker.
