Idea
In short
How do you build a lawn mower robot model?
A model mower stays inside a boundary wire and cuts in stripes. You need ESP32 DevKit V1, L298N Dual H-Bridge Module, TT gear motor 3 to 6 V × 2, Coreless motor 8520 (drone), Enamelled copper wire (magnet wire, 0.3 mm), LM393 Comparator and Li-Po 2S 7.4 V 2200 mAh 25C (RC).
- Level
- Advanced
- Time
- About 600 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Detect a boundary wire.
Parts list
- Development Boards
- Motor Drivers
- Motors & Actuators
- Motors & ActuatorsAs the blade motor model
- Cables & Wires
- Integrated Circuits
- Batteries
How to build it
- Lay a signal wire around the area
- Detect it with a coil
- Turn away at the wire
- Run stripes
- Stop if lifted
Common questions
What parts do I need for the lawn mower robot model?
ESP32 DevKit V1, L298N Dual H-Bridge Module, TT gear motor 3 to 6 V × 2, Coreless motor 8520 (drone), Enamelled copper wire (magnet wire, 0.3 mm), LM393 Comparator and Li-Po 2S 7.4 V 2200 mAh 25C (RC). Coreless motor 8520 (drone): As the blade motor model.
How long does the lawn mower robot model take to build?
About 600 minutes for a advanced maker.
