Idea
In short
How do you build an RC car speed controller tester?
Test brushless ESCs and motors on a bench with throttle curves and temperature logging. You need Arduino Nano, 30 A brushless ESC, Brushless motor A2212 1000 KV, INA226 current and power monitor, DS18B20 Temperature Sensor, Resistor 4.7 kΩ and Li-Po 3S 11.1 V 2200 mAh 30C (drone).
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure ESC and motor performance.
Parts list
- Development Boards
- Motors & Actuators
- Motors & Actuators
- Sensors
- Sensors
- Passives
- Batteries
How to build it
- Clamp the motor securely
- Ramp throttle in steps
- Log current, voltage and temperature
- Plot power against throttle
- Wear eye protection and no props
Common questions
What parts do I need for the RC car speed controller tester?
Arduino Nano, 30 A brushless ESC, Brushless motor A2212 1000 KV, INA226 current and power monitor, DS18B20 Temperature Sensor, Resistor 4.7 kΩ and Li-Po 3S 11.1 V 2200 mAh 30C (drone).
How long does the RC car speed controller tester take to build?
About 180 minutes for a intermediate maker.
