Projects / Ideas / 3D printed prosthetic hand

3D printed prosthetic hand

AdvancedAssistive TechIdeaReviewed
In short

How do you build a 3D printed prosthetic hand?

A printed hand with five servos curls its fingers from an EMG sensor or flex glove. You need Arduino Nano, SG90 Micro Servo × 5, EMG muscle sensor (MyoWare 2.0), PCA9685 16-channel servo driver, Li-Po 2S 7.4 V 2200 mAh 25C (RC) and LM2596 Buck Module.

Level
Advanced
Time
About 720 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Drive tendons with servos from a biosignal.

How to build it

  1. Print an open-source hand design
  2. Thread tendons to each servo
  3. Read the EMG signal
  4. Close and open on muscle tension
  5. Add grip patterns

Related projects

Common questions

What parts do I need for the 3D printed prosthetic hand?

Arduino Nano, SG90 Micro Servo × 5, EMG muscle sensor (MyoWare 2.0), PCA9685 16-channel servo driver, Li-Po 2S 7.4 V 2200 mAh 25C (RC) and LM2596 Buck Module.

How long does the 3D printed prosthetic hand take to build?

About 720 minutes for a advanced maker.