Projects / Ideas / Op-amp slew rate lab

Op-amp slew rate lab

IntermediateLearningIdeaReviewed
In short

How do you build an op-amp slew rate lab?

Feed a square wave to an op-amp buffer and observe the slew limit on a scope. You need LM358 Op-Amp, TL071 low-noise JFET op-amp, Resistor 10 kΩ × 2, Potentiometer 10 kΩ, Breadboard 830 Tie Points, 9 V battery and 9 V battery.

Level
Intermediate
Time
About 210 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See slew rate in practice.

Parts list

How to build it

  1. Build a unity-gain buffer
  2. Feed a square wave
  3. Measure rise time
  4. Compare two op-amps
  5. Plot against frequency

Related projects

Common questions

What parts do I need for the op-amp slew rate lab?

LM358 Op-Amp, TL071 low-noise JFET op-amp, Resistor 10 kΩ × 2, Potentiometer 10 kΩ, Breadboard 830 Tie Points, 9 V battery and 9 V battery.

How long does the op-amp slew rate lab take to build?

About 210 minutes for a intermediate maker.