Idea
In short
How do you build an instrumentation amplifier demo?
An instrumentation amplifier reads a tiny bridge voltage from a strain gauge or thermistor bridge. You need INA128 instrumentation amplifier, Resistor 1 kΩ × 4, Potentiometer 10 kΩ, Arduino Uno R3, Breadboard 830 Tie Points, 9 V battery and 9 V battery.
- Level
- Advanced
- Time
- About 270 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
See how an in-amp rejects common-mode noise.
Parts list
- Integrated Circuits
- PassivesResistor 1 kΩ × 4
- Passives
- Development Boards
- Prototyping
- Batteries
- Batteries
How to build it
- Build a small bridge
- Set the gain with one resistor
- Read with the ADC
- Add common-mode noise
- Compare with a single op-amp
Common questions
What parts do I need for the instrumentation amplifier demo?
INA128 instrumentation amplifier, Resistor 1 kΩ × 4, Potentiometer 10 kΩ, Arduino Uno R3, Breadboard 830 Tie Points, 9 V battery and 9 V battery.
How long does the instrumentation amplifier demo take to build?
About 270 minutes for a advanced maker.
