How do you build a motor torque lever lab?
A small motor turns a lever that presses on a load cell, and the force at a known arm length gives its torque for different speeds. It is a careful way to see why a motor has less torque when it turns faster. Limit the power, run only for a moment at a time, and never hold a stalled motor. You need Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, HX711 load cell amplifier, Load cell 5 kg (bar type), SSD1306 OLED Display, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 10
Estimate a small motor's torque with a lever.
Parts list
- Development Boards
- Motors & Actuators
- Motor Drivers
- Sensors
- Sensors
- Displays
- Power
- Batteries
- Prototyping
- Prototyping
How to build it
- Fix a lever of known length to the motor
- Press the lever against the load cell
- Run at a few set speeds for a moment
- Calculate torque from force and arm length
- Chart torque against speed
Common questions
What parts do I need for the motor torque lever lab?
Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, HX711 load cell amplifier, Load cell 5 kg (bar type), SSD1306 OLED Display, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the motor torque lever lab take to build?
About 120 minutes for a intermediate maker.
