Components / Motors and drivers / TB6612FNG Motor Driver

TB6612FNG Motor Driver

Dual motor driver IC/carrier family for suitable brushed motors.

FunctionDual MOSFET H-bridge motor driver
Supply voltageMotor 4.5 to 13.5 V (VM); logic 2.7 to 5.5 V (VCC)
InterfacePWMA/PWMB speed, AIN1/AIN2 and BIN1/BIN2 direction, STBY
Rating1.2 A per channel continuous, 3.2 A peak
Motor DriversReviewedMPN TB6612FNG breakoutUsed in 36 projects
In short

What is the TB6612FNG Motor Driver and what is it used for?

Dual motor driver IC/carrier family for suitable brushed motors. Makers use it for practice independent logic and motor power.

In the real world

Battery-powered robotics

How it works

Motor drivers handle inductive loads under specified electrical and thermal limits; motor stall current matters.

Key specifications

Interface module specValue
FunctionDual MOSFET H-bridge motor driver
Supply voltageMotor 4.5 to 13.5 V (VM); logic 2.7 to 5.5 V (VCC)
InterfacePWMA/PWMB speed, AIN1/AIN2 and BIN1/BIN2 direction, STBY
Rating1.2 A per channel continuous, 3.2 A peak
Logic level3.3 V or 5 V

Pinout

VMMotor supply
VCCLogic supply
GNDGround
STBYPull HIGH to enable
PWMA / AIN1 / AIN2Motor A speed and direction
PWMB / BIN1 / BIN2Motor B
AO1, AO2, BO1, BO2Motor outputs

How to use it

Works with 3.3 V boards and wastes far less power than the L298N. Remember STBY: if it is low, nothing moves.

const int PWMA = 5, AIN1 = 7, AIN2 = 8, STBY = 6;
void setup() { for (int p : {PWMA, AIN1, AIN2, STBY}) pinMode(p, OUTPUT); digitalWrite(STBY, HIGH); }
void loop() { digitalWrite(AIN1, HIGH); digitalWrite(AIN2, LOW); analogWrite(PWMA, 200); delay(2000); analogWrite(PWMA, 0); delay(1000); }

Applications

Alternatives

Buy at

Common questions

What is the TB6612FNG Motor Driver used for?

In products: battery-powered robotics. In maker projects: practice independent logic and motor power.

How does the TB6612FNG Motor Driver work?

Motor drivers handle inductive loads under specified electrical and thermal limits; motor stall current matters.

What voltage does the TB6612FNG Motor Driver need?

Motor 4.5 to 13.5 V (VM); logic 2.7 to 5.5 V (VCC).

How do I connect the TB6612FNG Motor Driver to an Arduino or ESP32?

PWMA/PWMB speed, AIN1/AIN2 and BIN1/BIN2 direction, STBY. Pins: VM (Motor supply), VCC (Logic supply), GND (Ground), STBY (Pull HIGH to enable), PWMA / AIN1 / AIN2 (Motor A speed and direction), PWMB / BIN1 / BIN2 (Motor B).

What can I use instead of the TB6612FNG Motor Driver?

L298N Dual H-Bridge Module.