Projects / Ideas / Model forklift lift

Model forklift lift

IntermediateRoboticsIdeaReviewed
In short

How do you build a model forklift lift?

A small gear motor lifts and lowers the forks of a model forklift on a string, stopping at a top and a bottom limit switch, with two buttons for up and down. It shows how a limit switch protects a mechanism. A toy only, with fingers kept clear of the string. You need Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, Limit switch (micro switch with lever) × 2, Tactile push button 6 mm × 2, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Lift and lower model forks safely.

How to build it

  1. Wire the motor driver and the two limit switches
  2. Run up while a button is held
  3. Stop at the top switch
  4. Run down while the other button is held
  5. Stop at the bottom switch

Related projects

Common questions

What parts do I need for the model forklift lift?

Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, Limit switch (micro switch with lever) × 2, Tactile push button 6 mm × 2, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the model forklift lift take to build?

About 100 minutes for a intermediate maker.