Projects / Ideas / Model hoist winch

Model hoist winch

BeginnerIndustrialIdeaReviewed
In short

How do you build a model hoist winch?

A small motor winds a string on a drum to raise a light hook, with an upper limit switch that stops it before the hook reaches the drum, and an up and a down button. A good lesson in why hoists have end stops. Use only a very light load and keep fingers clear of the string. You need Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, Limit switch (micro switch with lever), Tactile push button 6 mm × 2, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 80 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Raise a model hook and stop at the top.

How to build it

  1. Wind a string on a small drum
  2. Raise the hook while a button is held
  3. Stop at the upper limit switch
  4. Lower the hook with the other button
  5. Add a slack-string stop

Related projects

Common questions

What parts do I need for the model hoist winch?

Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, Limit switch (micro switch with lever), Tactile push button 6 mm × 2, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the model hoist winch take to build?

About 80 minutes for a beginner maker.