Projects / Ideas / Pulse induction metal detector

Pulse induction metal detector

AdvancedTest & MeasurementIdeaReviewed
In short

How do you build a pulse induction metal detector?

A coil and timing circuit detect metal by the way eddy currents decay after a pulse. You need Arduino Nano, Enamelled copper wire (magnet wire, 0.3 mm), IRF840 N-channel MOSFET (500 V), Signal Diode 1N4148, Resistor 1 kΩ, Ceramic Capacitor 100 nF, LM358 Op-Amp, Passive buzzer and 9 V battery.

Level
Advanced
Time
About 300 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Understand eddy currents.

Parts list

How to build it

  1. Wind a coil
  2. Pulse it with a MOSFET
  3. Sample the decay
  4. Compare with a no-metal baseline
  5. Tune sensitivity

Related projects

Common questions

What parts do I need for the pulse induction metal detector?

Arduino Nano, Enamelled copper wire (magnet wire, 0.3 mm), IRF840 N-channel MOSFET (500 V), Signal Diode 1N4148, Resistor 1 kΩ, Ceramic Capacitor 100 nF, LM358 Op-Amp, Passive buzzer and 9 V battery.

How long does the pulse induction metal detector take to build?

About 300 minutes for a advanced maker.