Projects / Ideas / Analog light meter with a photodiode

Analog light meter with a photodiode

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build an analog light meter with a photodiode?

A photodiode and an op-amp turn light into a voltage, shown on a board input and a little bar of LEDs. You need Arduino Nano, Photodiode BPW34, LM358 Op-Amp, Resistor 100 kΩ, Resistor 1 kΩ, 9 V battery, 9 V battery snap with DC jack, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 270 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Measure light with a photodiode.

How to build it

  1. Wire the photodiode in current mode
  2. Add the op-amp stage
  3. Read the output
  4. Calibrate against a lamp
  5. Show relative brightness

Related projects

Common questions

What parts do I need for the analog light meter with a photodiode?

Arduino Nano, Photodiode BPW34, LM358 Op-Amp, Resistor 100 kΩ, Resistor 1 kΩ, 9 V battery, 9 V battery snap with DC jack, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the analog light meter with a photodiode take to build?

About 270 minutes for a intermediate maker.