Idea
In short
How do you build a programmable DC voltage source?
A 12-bit DAC and an op-amp buffer make a small adjustable voltage source from 0 to 4 V for testing circuits. You need Arduino Uno R3, MCP4725 12-bit DAC module, MCP6002 rail-to-rail op-amp, SSD1306 OLED Display, Rotary encoder module (KY-040), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Generate a precise voltage from a microcontroller.
Parts list
- Development Boards
- Integrated Circuits
- Integrated Circuits
- Displays
- Sensors
- Prototyping
- Prototyping
How to build it
- Wire the DAC over I2C
- Buffer the output with an op-amp
- Set the voltage with an encoder
- Show it on the OLED
- Check against a multimeter
Common questions
What parts do I need for the programmable DC voltage source?
Arduino Uno R3, MCP4725 12-bit DAC module, MCP6002 rail-to-rail op-amp, SSD1306 OLED Display, Rotary encoder module (KY-040), Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the programmable DC voltage source take to build?
About 210 minutes for a intermediate maker.
