Idea
In short
How do you build a simple frequency counter?
Count pulses on one input over a one-second gate to show a frequency up to a few hundred kilohertz. You need Arduino Uno R3, SSD1306 OLED Display, Resistor 1 kΩ, Signal Diode 1N4148, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use hardware timers to count edges.
Parts list
- Development Boards
- Displays
- Passives
- Semiconductors
- Prototyping
- Prototyping
How to build it
- Condition the input with a resistor and diode
- Count edges with Timer1
- Open a gate for one second
- Show the frequency on the OLED
- Add a range switch
Common questions
What parts do I need for the simple frequency counter?
Arduino Uno R3, SSD1306 OLED Display, Resistor 1 kΩ, Signal Diode 1N4148, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the simple frequency counter take to build?
About 240 minutes for a intermediate maker.
