Projects / Ideas / Cell capacity tester

Cell capacity tester

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a cell capacity tester?

Discharge a single cell through a resistor and log voltage over time to estimate its real capacity. You need Arduino Uno R3, 18650 Li-ion cell, Battery holder 18650 single, Wirewound resistor 1 Ω 10 W, MOSFET IRLZ44N, Resistor 1 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 270 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Measure real battery capacity safely.

How to build it

  1. Calculate the discharge current
  2. Switch the load with a MOSFET
  3. Log voltage each minute
  4. Stop at 3.0 V
  5. Compute mAh and plot the curve

Related projects

Common questions

What parts do I need for the cell capacity tester?

Arduino Uno R3, 18650 Li-ion cell, Battery holder 18650 single, Wirewound resistor 1 Ω 10 W, MOSFET IRLZ44N, Resistor 1 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the cell capacity tester take to build?

About 270 minutes for a intermediate maker.