Idea
In short
How do you build a heat test of a 5 V regulator module?
Run a 5 V regulator module at different input voltages and loads and see how the heat rises, using a fan to bring it down. Hot parts burn, so touch only after power off. You need LM7805 module with heatsink, 9 V battery, 9 V battery snap with DC jack, Resistor 10 kΩ, Resistor 33 kΩ, 5 V DC fan 40 mm, Digital multimeter and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 120 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
See how a linear regulator wastes power.
Parts list
- Power
- Batteries
- Power
- Passives
- Passives
- Motors & Actuators
- Tools & Instruments
- Prototyping
How to build it
- Calculate the wasted watts
- Run with a light load
- Raise the input voltage
- Add the fan
- Compare calculated and measured heat
Common questions
What parts do I need for the heat test of a 5 V regulator module?
LM7805 module with heatsink, 9 V battery, 9 V battery snap with DC jack, Resistor 10 kΩ, Resistor 33 kΩ, 5 V DC fan 40 mm, Digital multimeter and Breadboard 830 Tie Points.
How long does the heat test of a 5 V regulator module take to build?
About 120 minutes for a beginner maker.
