Idea
In short
How do you build a digital thermostat with an I2C sensor?
A digital sensor with an alert pin flags when a room passes a set temperature, with no polling needed. You need Arduino Nano, LM75 temperature sensor, LED 5 mm red, Resistor 220 Ω, Active buzzer 5 V and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use a temperature alert pin.
Parts list
- Development Boards
- Sensors
- Semiconductors
- Passives
- Motors & Actuators
- Prototyping
How to build it
- Wire the sensor on I2C
- Read the temperature
- Set the limit registers
- Watch the alert pin
- Light the LED on alert
Common questions
What parts do I need for the digital thermostat with an I2C sensor?
Arduino Nano, LM75 temperature sensor, LED 5 mm red, Resistor 220 Ω, Active buzzer 5 V and Breadboard 830 Tie Points.
How long does the digital thermostat with an I2C sensor take to build?
About 240 minutes for a intermediate maker.
