Projects / Ideas / Birdbath water level alert

Birdbath water level alert

BeginnerEnvironmentIdeaReviewed
In short

How do you build a birdbath water level alert?

A non-contact sensor stuck to the outside of a birdbath bowl warns when the water gets low so you can top it up, since birds need fresh water in hot weather. The sensor board stays dry on the rim. Keep all electronics away from standing water. You need Arduino Nano, Water level sensor (non-contact, XKC-Y25), LED 5 mm red, Resistor 220 Ω, Passive buzzer, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 60 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Remind you to top up the birdbath.

How to build it

  1. Stick the sensor to the outside of the bowl at the low mark
  2. Check it reads wet and dry
  3. Light the LED when water drops
  4. Add a gentle beep once a day
  5. Keep the board dry under a lid

Related projects

Common questions

What parts do I need for the birdbath water level alert?

Arduino Nano, Water level sensor (non-contact, XKC-Y25), LED 5 mm red, Resistor 220 Ω, Passive buzzer, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the birdbath water level alert take to build?

About 60 minutes for a beginner maker.