Projects / Ideas / Li-ion low-voltage cutoff

Li-ion low-voltage cutoff

IntermediatePowerIdeaReviewed
In short

How do you build a li-ion low-voltage cutoff?

An LM393 comparator watches a single 18650 cell against a zener reference and switches off the load through a logic-level MOSFET when the cell falls to about 3.2 V, with a red LED showing the cutoff. It does not replace a proper protection board or charger. You need 18650 Li-ion cell, Battery holder 18650 single, LM393 Comparator, Zener diode 3.3 V (1N4728A), Trimmer potentiometer 10 kΩ (3296), MOSFET IRLZ44N, Resistor 10 kΩ × 2, Resistor 1 kΩ, LED 5 mm red and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 180 min
Parts
10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Stop a cell being run flat by its load.

How to build it

  1. Set the threshold with the trimmer on a bench supply
  2. Wire the comparator and the zener
  3. Switch the load with the MOSFET
  4. Add the cutoff LED
  5. Test with a small lamp load

Related projects

Common questions

What parts do I need for the li-ion low-voltage cutoff?

18650 Li-ion cell, Battery holder 18650 single, LM393 Comparator, Zener diode 3.3 V (1N4728A), Trimmer potentiometer 10 kΩ (3296), MOSFET IRLZ44N, Resistor 10 kΩ × 2, Resistor 1 kΩ, LED 5 mm red and Breadboard 830 Tie Points.

How long does the li-ion low-voltage cutoff take to build?

About 180 minutes for a intermediate maker.