Projects / Ideas / Jetson Orin Nano button and LED

Jetson Orin Nano button and LED

BeginnerLearningIdeaReviewed
In short

How do you build a jetson Orin Nano button and LED?

A Jetson Orin Nano reads a push button and lights an LED with the Jetson.GPIO library, the first step before sensors. Use a 3.3 V logic level on the header and shut down before changing wiring. You need NVIDIA Jetson Orin Nano 4 GB module, LED 5 mm red, Resistor 330 Ω, Tactile push button 6 mm and Breadboard 830 Tie Points.

Level
Beginner
Time
About 100 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Use the Jetson's GPIO pins.

How to build it

  1. Check the header numbering
  2. Wire the LED with a resistor
  3. Wire the button to ground
  4. Read the button with Jetson.GPIO
  5. Toggle the LED on each press

Related projects

Common questions

What parts do I need for the jetson Orin Nano button and LED?

NVIDIA Jetson Orin Nano 4 GB module, LED 5 mm red, Resistor 330 Ω, Tactile push button 6 mm and Breadboard 830 Tie Points.

How long does the jetson Orin Nano button and LED take to build?

About 100 minutes for a beginner maker.