Idea
In short
How do you build a touch latch with a PNP?
Two complementary transistors make a latch that stays on after a touch until reset, a first look at positive feedback. You need BC547 NPN transistor, BC557 PNP transistor, Resistor 10 kΩ × 2, Resistor 1 kΩ, Tactile push button 6 mm, LED 5 mm red, Resistor 330 Ω, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a transistor latch.
Parts list
- Semiconductors
- Semiconductors
- PassivesResistor 10 kΩ × 2
- Passives
- Switches
- Semiconductors
- Passives
- Batteries
- Power
- Prototyping
How to build it
- Wire the pair
- Add the set contacts
- Latch on a touch
- Add a reset button
- Measure the holding current
Common questions
What parts do I need for the touch latch with a PNP?
BC547 NPN transistor, BC557 PNP transistor, Resistor 10 kΩ × 2, Resistor 1 kΩ, Tactile push button 6 mm, LED 5 mm red, Resistor 330 Ω, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the touch latch with a PNP take to build?
About 210 minutes for a intermediate maker.
