433 MHz RF transmitter and receiver pair
Simplest one-way radio link for remote buttons.
What is the 433 MHz RF transmitter and receiver pair and what is it used for?
Simplest one-way radio link for remote buttons. Makers use it for remote switches, doorbells.
The transmitter switches a 433 MHz carrier on and off with the data, and the receiver detects the carrier and outputs the pattern.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | ASK / OOK |
| Band | 433 MHz ISM |
| Typical range | About 20 to 100 m with an antenna |
| Interface | Digital data pin |
| Supply voltage | 3 to 12 V transmitter, 5 V receiver |
Pinout
How to use it
Use the RadioHead RH_ASK library (default TX on pin 12 and RX on pin 11). Solder a 17.3 cm straight wire to the ANT pad of each board for a quarter-wave antenna. Expect noise when idle, so always send short packets with a checksum.
Applications
Builds that use it
Rodent trap alert for godowns
Wireless indoor-outdoor thermometer
Decode a 433 MHz weather sensor
Sensor bridge to Home Assistant
Wireless doorbell with your own tunes
Wireless doorbell
Bike that starts only with the helmet on
Listen to cheap weather stations
Alternatives
- nRF24L01+ Radio ModuleTwo-way, more reliable packets
- CC1101 sub-GHz transceiverTwo-way sub-GHz with proper packet handling
Common questions
What is the 433 MHz RF transmitter and receiver pair used for?
In maker projects: remote switches, doorbells.
How does the 433 MHz RF transmitter and receiver pair work?
The transmitter switches a 433 MHz carrier on and off with the data, and the receiver detects the carrier and outputs the pattern.
What voltage does the 433 MHz RF transmitter and receiver pair need?
3 to 12 V transmitter, 5 V receiver.
How do I connect the 433 MHz RF transmitter and receiver pair to an Arduino or ESP32?
Digital data pin. Pins: TX DATA (Data in from the board), TX VCC (3 to 12 V (more volts, more range)), TX GND (Ground), RX VCC (5 V), RX DATA (Data out (either middle pin)), RX GND (Ground).
What can I use instead of the 433 MHz RF transmitter and receiver pair?
nRF24L01+ Radio Module and CC1101 sub-GHz transceiver.
