Projects / Ideas / Flex-controlled servo hand

Flex-controlled servo hand

IntermediateRoboticsIdeaReviewed
In short

How do you build a flex-controlled servo hand?

Bend a flex sensor and a small servo finger copies the movement, a simple teleoperation idea. You need Arduino Nano, Flex sensor 2.2 inch, SG90 Micro Servo, Resistor 10 kΩ and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 180 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Mirror a movement with a servo.

Parts list

How to build it

  1. Wire the sensor and servo
  2. Read and smooth the sensor
  3. Map to servo angle
  4. Add limits
  5. Try two sensors

Related projects

Common questions

What parts do I need for the flex-controlled servo hand?

Arduino Nano, Flex sensor 2.2 inch, SG90 Micro Servo, Resistor 10 kΩ and Breadboard 830 Tie Points.

How long does the flex-controlled servo hand take to build?

About 180 minutes for a intermediate maker.