Idea
In short
How do you build a supply noise filter lab?
Add a ferrite bead and an LC filter to a noisy low voltage rail and compare the ripple on a scope before and after. You need Ferrite bead (through-hole), Inductor 10 µH (radial), Ceramic capacitor 47 nF, Electrolytic Capacitor 100 µF, Digital oscilloscope 2-channel 100 MHz and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Clean up a noisy supply.
Parts list
- Passives
- Passives
- Passives
- Passives
- Tools & Instruments
- Prototyping
How to build it
- Measure the raw ripple
- Add the bead
- Add the LC stage
- Measure again
- Calculate the filter cutoff
Common questions
What parts do I need for the supply noise filter lab?
Ferrite bead (through-hole), Inductor 10 µH (radial), Ceramic capacitor 47 nF, Electrolytic Capacitor 100 µF, Digital oscilloscope 2-channel 100 MHz and Breadboard 830 Tie Points.
How long does the supply noise filter lab take to build?
About 150 minutes for a intermediate maker.
