Projects / Ideas / Power supply ripple and load tester

Power supply ripple and load tester

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a power supply ripple and load tester?

Load a supply in steps and measure voltage drop and ripple to see if it meets its rating. You need Arduino Nano, MOSFET IRLZ44N × 2, Power resistor 10 Ω 5 W (cement) × 2, Electrolytic capacitor 10 µF, SSD1306 OLED Display and Digital oscilloscope 2-channel 100 MHz.

Level
Intermediate
Time
About 150 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Test a power supply properly.

How to build it

  1. Switch loads in steps
  2. Measure the DC voltage at each step
  3. Look at ripple on a scope with AC coupling
  4. Record a load curve
  5. Compare a cheap and a good adapter

Related projects

Common questions

What parts do I need for the power supply ripple and load tester?

Arduino Nano, MOSFET IRLZ44N × 2, Power resistor 10 Ω 5 W (cement) × 2, Electrolytic capacitor 10 µF, SSD1306 OLED Display and Digital oscilloscope 2-channel 100 MHz.

How long does the power supply ripple and load tester take to build?

About 150 minutes for a intermediate maker.