Projects / Ideas / ESP32 DevKitC pin map tour

ESP32 DevKitC pin map tour

BeginnerLearningIdeaReviewed
In short

How do you build an ESP32 DevKitC pin map tour?

Walk through the pins of an ESP32 DevKitC with an LED and a short test sketch: which pins are output only, input only, used at boot, or share the analog converter with Wi-Fi. You finish with your own one-page pin chart for later projects. You need ESP32-WROOM-32 DevKitC, LED 5 mm red, Resistor 220 Ω, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 80 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Learn which ESP32 pins are safe for what.

How to build it

  1. Install the board package and find the pinout
  2. Blink an LED on a safe pin
  3. Read a button on an input-only pin
  4. Compare analog readings with Wi-Fi on and off
  5. Write your own pin chart

Related projects

Common questions

What parts do I need for the ESP32 DevKitC pin map tour?

ESP32-WROOM-32 DevKitC, LED 5 mm red, Resistor 220 Ω, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the ESP32 DevKitC pin map tour take to build?

About 80 minutes for a beginner maker.