How do you build a ±12 V dual supply for op-amp labs?
A 12-0-12 transformer, bridge rectifier and 7812/7912 regulators make the split supply that op-amp experiments need. You need 7812 voltage regulator, 7912 negative voltage regulator, Bridge rectifier DB107 (1 A), Electrolytic capacitor 1000 µF × 2, Ceramic Capacitor 100 nF × 4, Electrolytic capacitor 10 µF × 2, LED 5 mm red, LED 5 mm green, Resistor 2.2 kΩ × 2 and ABS project box (100 × 60 × 25 mm).
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 10
Build a dual linear supply and check ripple and regulation.
Parts list
- Power
- Power
- Semiconductors
- Passives
- Passives
- Passives
- Semiconductors
- Semiconductors
- PassivesResistor 2.2 kΩ × 2
- Mechanical & Hardware
How to build it
- Use a 12-0-12 transformer with a fuse on the primary, wired by a qualified person
- Rectify and smooth both halves
- Regulate +12 V and −12 V
- Check ripple on each rail with an oscilloscope
- Load each rail with 100 mA and check it stays in limits
Common questions
What parts do I need for the ±12 V dual supply for op-amp labs?
7812 voltage regulator, 7912 negative voltage regulator, Bridge rectifier DB107 (1 A), Electrolytic capacitor 1000 µF × 2, Ceramic Capacitor 100 nF × 4, Electrolytic capacitor 10 µF × 2, LED 5 mm red, LED 5 mm green, Resistor 2.2 kΩ × 2 and ABS project box (100 × 60 × 25 mm).
How long does the ±12 V dual supply for op-amp labs take to build?
About 240 minutes for a intermediate maker.
