Idea
In short
How do you build a remote-controlled toy car?
A small motor driver and a radio link turn a toy chassis into a car steered with a joystick. You need Arduino Nano × 2, DRV8833 dual motor driver, TT gear motor 3 to 6 V × 2, nRF24L01+ Radio Module × 2, Joystick module (dual axis), 9 V battery and Breadboard 830 Tie Points × 2.
- Level
- Intermediate
- Time
- About 330 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Drive a car by remote.
Parts list
- Development BoardsArduino Nano × 2
- Motor Drivers
- Motors & Actuators
- Wireless
- Sensors
- Batteries
- Prototyping
How to build it
- Wire the car side
- Wire the remote side
- Send joystick values
- Mix into two motor speeds
- Add a safe stop on lost signal
Common questions
What parts do I need for the remote-controlled toy car?
Arduino Nano × 2, DRV8833 dual motor driver, TT gear motor 3 to 6 V × 2, nRF24L01+ Radio Module × 2, Joystick module (dual axis), 9 V battery and Breadboard 830 Tie Points × 2.
How long does the remote-controlled toy car take to build?
About 330 minutes for a intermediate maker.
