Idea
In short
How do you build a speed limiter model?
A model car reads its wheel speed and cuts motor power if it goes over a set limit. You need Arduino Nano, Optical encoder speed sensor (slot, LM393), L298N Dual H-Bridge Module, TT gear motor 3 to 6 V, Potentiometer 10 kΩ, Battery holder 4 × AA with switch and AA alkaline battery × 4.
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Close a control loop on speed.
Parts list
- Development Boards
- Sensors
- Motor Drivers
- Motors & Actuators
- Passives
- Power
- Batteries
How to build it
- Count encoder slots per second
- Convert to speed
- Set the limit with a pot
- Reduce PWM when over the limit
- Show speed on serial plot
Common questions
What parts do I need for the speed limiter model?
Arduino Nano, Optical encoder speed sensor (slot, LM393), L298N Dual H-Bridge Module, TT gear motor 3 to 6 V, Potentiometer 10 kΩ, Battery holder 4 × AA with switch and AA alkaline battery × 4.
How long does the speed limiter model take to build?
About 120 minutes for a intermediate maker.
