Idea
In short
How do you build a toner-transfer LED board?
Make a one-layer LED board by transferring a printed layout onto copper and etching it. Use gloves, eye protection and ventilation, and dispose of etchant properly. You need Copper clad board (single side) 10 × 15 cm, Ferric chloride (PCB etchant), Mini drill (PCB, 12 V), LED 5 mm red × 3, Resistor 330 Ω × 3 and 5 V 2 A USB adapter.
- Level
- Intermediate
- Time
- About 300 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Make a simple home PCB.
Parts list
- Prototyping
- Prototyping
- Tools & Instruments
- SemiconductorsLED 5 mm red × 3
- PassivesResistor 330 Ω × 3
- Power
How to build it
- Design a small layout
- Print and transfer it
- Etch the board
- Drill and clean it
- Solder the LEDs and test
Common questions
What parts do I need for the toner-transfer LED board?
Copper clad board (single side) 10 × 15 cm, Ferric chloride (PCB etchant), Mini drill (PCB, 12 V), LED 5 mm red × 3, Resistor 330 Ω × 3 and 5 V 2 A USB adapter.
How long does the toner-transfer LED board take to build?
About 300 minutes for a intermediate maker.
