Projects / Ideas / Etch your first PCB

Etch your first PCB

IntermediateLearningIdeaReviewed
In short

How do you build an etch your first PCB?

You draw a simple circuit, transfer it to copper board, etch it, drill it and solder an LED flasher. Etchant is hazardous: read the safety notes and wear eye protection and gloves. You need Copper clad board (single side) 10 × 15 cm, Ferric chloride (PCB etchant), Mini drill (PCB, 12 V), NE555 Timer IC, LED 5 mm red, Resistor 220 Ω, Resistor 10 kΩ, Electrolytic capacitor 10 µF, Soldering flux paste and Isopropyl alcohol 99 % (flux cleaner).

Level
Intermediate
Time
About 360 min
Parts
10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Make a single-sided PCB at home.

How to build it

  1. Draw the layout with wide traces
  2. Transfer to the board
  3. Etch following the safety notes
  4. Clean and drill
  5. Solder and test

Related projects

Common questions

What parts do I need for the etch your first PCB?

Copper clad board (single side) 10 × 15 cm, Ferric chloride (PCB etchant), Mini drill (PCB, 12 V), NE555 Timer IC, LED 5 mm red, Resistor 220 Ω, Resistor 10 kΩ, Electrolytic capacitor 10 µF, Soldering flux paste and Isopropyl alcohol 99 % (flux cleaner).

How long does the etch your first PCB take to build?

About 360 minutes for a intermediate maker.