Idea
In short
How do you build a phone-controlled servo claw?
A phone app opens and closes a small claw on a servo through a Bluetooth module. You need Arduino Nano, HC-06 Bluetooth module, SG90 Micro Servo, Resistor 1 kΩ, Resistor 4.7 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Control a servo over Bluetooth serial.
Parts list
- Development Boards
- Wireless
- Motors & Actuators
- Passives
- Passives
- Prototyping
How to build it
- Divide the TX signal for the module
- Pair with a phone
- Send commands
- Move the servo
- Add limits
Common questions
What parts do I need for the phone-controlled servo claw?
Arduino Nano, HC-06 Bluetooth module, SG90 Micro Servo, Resistor 1 kΩ, Resistor 4.7 kΩ and Breadboard 830 Tie Points.
How long does the phone-controlled servo claw take to build?
About 210 minutes for a intermediate maker.
