Idea
In short
How do you build a bike rear light with brake flash?
A rear bike light flashes brighter when the bike slows down, detected with an accelerometer. You need Arduino Nano, MPU6050 IMU, LED 5 mm red × 6, Resistor 220 Ω × 6, MOSFET IRLZ44N, Li-Po battery 3.7 V 1000 mAh, TP4056 module with protection (USB-C) and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Detect deceleration with an IMU.
Parts list
- Development Boards
- Sensors
- SemiconductorsLED 5 mm red × 6
- PassivesResistor 220 Ω × 6
- Semiconductors
- Batteries
- Power
- Prototyping
How to build it
- Read acceleration along the bike
- Detect braking
- Boost the brightness
- Add a steady mode
- Check visibility and follow local rules
Related projects
Common questions
What parts do I need for the bike rear light with brake flash?
Arduino Nano, MPU6050 IMU, LED 5 mm red × 6, Resistor 220 Ω × 6, MOSFET IRLZ44N, Li-Po battery 3.7 V 1000 mAh, TP4056 module with protection (USB-C) and Breadboard 830 Tie Points.
How long does the bike rear light with brake flash take to build?
About 240 minutes for a intermediate maker.
