Projects / Ideas / Bike brake light clip

Bike brake light clip

IntermediateVehiclesIdeaReviewed
In short

How do you build a bike brake light clip?

A small motion sensor on a bike lights extra red LEDs brighter when the bike slows down quickly, as a brake light would. It adds to your normal lights and never replaces them, and you should check your local rules for lights. Power it from a small USB bank and keep it dry. You need Arduino Nano, MPU6050 IMU, LED 5 mm red × 3, Resistor 220 Ω × 3, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 90 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Light up brighter when the bike brakes hard.

Parts list

How to build it

  1. Read the forward acceleration
  2. Remove the steady tilt value
  3. Light a steady red when riding
  4. Brighten and blink when slowing quickly
  5. Test it by pushing the bike along a path

Related projects

Common questions

What parts do I need for the bike brake light clip?

Arduino Nano, MPU6050 IMU, LED 5 mm red × 3, Resistor 220 Ω × 3, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the bike brake light clip take to build?

About 90 minutes for a intermediate maker.