Projects / Ideas / Battery tab spot welder controller

Battery tab spot welder controller

AdvancedPowerIdeaReviewed
In short

How do you build a battery tab spot welder controller?

An Arduino fires a precise pulse through high-current MOSFETs from a car battery to weld nickel strip onto 18650 cells. You need Arduino Nano, IRF3205 N-channel MOSFET × 4, IR2110 MOSFET gate driver, Foot switch (momentary), Nickel strip 0.15 mm (for battery packs), Silicone wire 18 AWG (red and black), SSD1306 OLED Display and Rotary encoder module (KY-040).

Level
Advanced
Time
About 360 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Switch very high currents for milliseconds and stay safe.

How to build it

  1. Use a car battery as the current source
  2. Parallel four MOSFETs on a thick copper bus
  3. Fire a pre-pulse, a gap and a main pulse set with the encoder
  4. Trigger with a foot switch
  5. Wear safety glasses: sparks fly

Related projects

Common questions

What parts do I need for the battery tab spot welder controller?

Arduino Nano, IRF3205 N-channel MOSFET × 4, IR2110 MOSFET gate driver, Foot switch (momentary), Nickel strip 0.15 mm (for battery packs), Silicone wire 18 AWG (red and black), SSD1306 OLED Display and Rotary encoder module (KY-040).

How long does the battery tab spot welder controller take to build?

About 360 minutes for a advanced maker.