Learn / Basics / AC and RMS

Impedance, Reactance and Phase

ReviewedAdvanced ProAbout 6 min
Vout = 2.5 V
In short

Impedance, Reactance and Phase: the short answer

Resistors oppose current the same way at every frequency. Capacitors and inductors do not.

Level
Advanced
Time
About 6 min
Topic
Basics
You will learn to

Calculate the reactance of capacitors and inductors, combine them with resistance into impedance, and understand phase shift.

Before this: AC, RMS and Real Power, RC Filters and Time Constants

Resistors oppose current the same way at every frequency. Capacitors and inductors do not. Their opposition, called reactance, depends on frequency: a capacitor's reactance is Xc = 1 ÷ (2πfC), which falls as frequency rises, and an inductor's is XL = 2πfL, which rises with frequency. A 100 nF capacitor is 1.6 kΩ at 1 kHz but only 1.6 Ω at 1 MHz, which is exactly why it works as a decoupling capacitor: it is almost a short circuit for fast noise and an open circuit for DC.

Reactance also shifts the timing between voltage and current. In a capacitor the current leads the voltage by 90°; in an inductor it lags by 90°. Because of this, you cannot simply add a resistance and a reactance. In series, the total impedance has magnitude |Z| = √(R² + X²), and the phase angle is φ = arctan(X ÷ R). Engineers write impedance as a complex number, Z = R + jX, so that the usual series and parallel rules still work with complex arithmetic.

Impedance explains filters, resonance and power factor. An RC low-pass filter's output falls to 70.7 % (−3 dB) at the frequency where Xc = R, that is f = 1 ÷ (2πRC). An LC circuit resonates where XL = Xc, f = 1 ÷ (2π√(LC)), which is how radios tune and how a buck converter's output filter can ring if it is badly damped. In AC power, phase between voltage and current is why real power is V × I × cos φ, not just V × I.

Reactance changes with frequency

A capacitor's reactance is 1 ÷ (2π f C), which falls as frequency rises, and an inductor's is 2π f L, which rises. A 100 nF capacitor has about 1.6 kΩ at 1 kHz and 16 Ω at 100 kHz. That is why capacitors pass AC and block DC, and inductors do the opposite.

Impedance combines resistance and reactance. Because the two are 90 degrees apart, they add as a right-angled triangle, not as plain numbers: the magnitude of Z is the square root of R squared plus X squared.

Phase

In a capacitor the current leads the voltage by up to 90 degrees, and in an inductor it lags. In an RC circuit, the phase shift grows with frequency, reaching 45 degrees at the corner frequency, which is also where a filter's output is 70 percent of the input.

Series resonance of an inductor and capacitor happens when the two reactances are equal and cancel, leaving only the resistance. The impedance is then at its lowest, and the current at its highest.

Using it

Impedance explains why a sensor with high source impedance needs a buffer, why a long cable loads a signal, and how speakers and antennas are matched. Always state the frequency when you quote an impedance, since it changes with it.

Common mistakes
  • Adding resistance and reactance as plain numbers.
  • Quoting an impedance without the frequency.
  • Forgetting that a capacitor's reactance falls as frequency rises.
Key formulas
Xc = 1 ÷ (2πfC)
capacitor reactance, falls with frequency
XL = 2πfL
inductor reactance, rises with frequency
|Z| = √(R² + X²)
series resistance and reactance
Try it: Find resonance

Where the two reactances cross

10 Ω100 Ω1 kΩ10 kHz100 kHz1 MHzFrequency159 kHz

XL rises with frequency and Xc falls. Where they cross, they cancel: that is the resonant frequency.

f0 = 1 ÷ (2π√(LC)) = 159 kHz

XL (inductor)Xc (capacitor)Reactance against frequency. XL rises and Xc falls; they are equal at 159 kHz, the resonant frequency.

Work it with your own numbers: Capacitive reactance · Inductive reactance · RLC series

Advanced lesson · Pro plan

Practise this lesson with Pro

The explanation above is free for everyone. The practice for Advanced lessons in every domain are part of the Pro plan at ₹999 a month.

With Pro you also get: a worked example, a hands-on task, a 3-question check.

Common questions

What will I learn in "Impedance, Reactance and Phase"?

Calculate the reactance of capacitors and inductors, combine them with resistance into impedance, and understand phase shift.