Tools / Capacitive Reactance
How to work out capacitive reactance
A capacitor blocks DC but passes AC, more easily the higher the frequency. Reactance puts a number on that, in ohms.
Xc = 1 / (2πfC)
Result
- Reactance
- 1.592 kΩ
What this leaves out
- Ideal linear capacitor; parasitic ESR/ESL and voltage rating not modeled.
Step by step
The working with your numbers
- Change nanofarads to farads
C = 100 nF ÷ 1,000,000,000 = 10⁻⁷ F - Multiply 2π × f × C
2π × 1,000 × 10⁻⁷ = 0.000628 - Reactance
Xc = 1 ÷ 0.000628 = 1.59 kΩ
See it
Reactance falls as frequency rises
Does the answer make sense?
- OK: At ten times the frequency (10 kHz) the reactance is ten times smaller: 159 Ω.
- OK: At DC (0 Hz) reactance is infinite: a capacitor blocks steady current once charged.
- OK: Current through a capacitor leads the voltage by 90°, so Xc does not simply add to a resistance. In series use |Z| = √(R² + Xc²).
Common mistakes
- Forgetting the 2π. Using 1 ÷ (fC) gives an answer about 6.3 times too big.
- Leaving C in nF or µF. The formula needs farads.
- Adding Xc straight to R. They are at right angles, so combine them as √(R² + X²).
Learn it, try it, build it
Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.
Just need the number? Use the capacitive reactance calculator on Geekobot.
Common questions
How do you calculate capacitive reactance?
Xc = 1 ÷ (2π × f × C) with f in hertz and C in farads. A 100 nF capacitor at 1 kHz is 1 ÷ (6.283 × 1,000 × 0.0000001) ≈ 1.59 kΩ.
Why is a 100 nF capacitor used for decoupling?
At high frequencies its reactance is very low (about 1.6 Ω at 1 MHz), so it shorts fast noise to ground, while at DC it blocks completely and does not load the supply.
