Lab / Virtual lab / Op-amps, timers and oscillators

555 monostable: pulse width

Measure the output pulse width for different timing resistors and check T = 1.1 RC.

Op-amps, timers and oscillatorsSimulatedFull experiment write-up →

Circuit

Updates as you change values
555+5 V6, 7R 10 kΩC 1 µF2trigger3

A 555 in monostable mode on 5 V; a short negative pulse on pin 2 triggers it; read the pulse width on the CRO.

Controls

Changing any setting except r starts a new set of readings.

Meters

Pulse width11 ms

Graph

0 readings

Your graph appears here

Take readings, or press Auto sweep to log a full set.

your readings

Theory

  • T = 1.1 R C (= RC ln 3)
  • Triggered when pin 2 falls below VCC / 3
  • Output stays high while C charges from 0 to 2VCC / 3
  • The trigger pulse must be shorter than T
  • Pin 4 (reset) low ends the pulse early

Worked out for your values

Pulse width T
11 ms
Fastest re-trigger rate
90.91 Hz
Charging current at start
500 µA

Your result

Worked out from your readings and compared with theory.

C from the slope of T against R

Take two or more readings at different R.

Sources of error

  • Capacitor tolerance and leakage
  • Threshold levels vary a little with supply voltage
  • Reading the pulse edge on the CRO