555 timer as a monostable multivibrator
To build a 555 monostable multivibrator and verify the pulse width T = 1.1RC.
Theory
A falling edge on the trigger (pin 2) below ⅓Vcc sets the output high and lets C charge through R. When the capacitor reaches ⅔Vcc, the output returns low and C discharges. The pulse width is T = 1.1RC, independent of the supply voltage.
Apparatus
- IC NE555
- Resistor R, capacitor C
- Push button with 10 kΩ pull-up
- DC supply
- CRO or LED
Circuit connections
- R from Vcc to pins 6 and 7, C from pins 6 and 7 to ground
- Trigger: pin 2 held high by 10 kΩ, pulled low by the button
Procedure
Pre-lab check
4 questions · 75% to be readyTry the readings before the lab
| Quantity | Value |
|---|---|
| T = 1.1RC | 1.1 s |
Precautions
- The trigger pulse must be shorter than T.
- Use a capacitor with low leakage for long delays.
My readings
Type what you measured. It goes into your record book, and to My Garage when you are signed in.
| S. No. | Quantity | Value |
|---|---|---|
| 1 | ||
| 2 | ||
| 3 | ||
| 4 | ||
| 5 | ||
| 6 |
Check my readings
Put the value you set in the first column, then compare. Real parts have tolerance.
Your lab record
Everything above is free. The print-ready write-up comes with Maker.
Printed pages leave the observation table empty for your own readings.
Viva practice
Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.
Quick answers for your record and viva
What is the aim of the 555 timer as a monostable multivibrator experiment?
To build a 555 monostable multivibrator and verify the pulse width T = 1.1RC.
What apparatus is needed for 555 timer as a monostable multivibrator?
IC NE555, Resistor R, capacitor C, Push button with 10 kΩ pull-up, DC supply, CRO or LED.
What is the theory behind 555 timer as a monostable multivibrator?
A falling edge on the trigger (pin 2) below ⅓Vcc sets the output high and lets C charge through R. When the capacitor reaches ⅔Vcc, the output returns low and C discharges. The pulse width is T = 1.1RC, independent of the supply voltage.
What result should I get in 555 timer as a monostable multivibrator?
Designed T = ___ s, measured T = ___ s.
What precautions should I take in 555 timer as a monostable multivibrator?
The trigger pulse must be shorter than T. Use a capacitor with low leakage for long delays.
