Lab / Virtual lab / Op-amps, timers and oscillators

Wien bridge oscillator

Check the oscillation frequency f = 1/(2πRC) and see why the amplifier gain must be at least 3.

Op-amps, timers and oscillatorsSimulatedFull experiment write-up →

Circuit

Updates as you change values
+−VOWien RC: R 10 kΩ, C 10 nFA = 3.11592 Hz

A 741 non-inverting amplifier with a series RC and a parallel RC (equal R and C) as positive feedback; read the output on the CRO.

Controls

Changing any setting except r starts a new set of readings.

Meters

Frequency1592 Hz
Output (p-p)14 V

Graph

0 readings

Your graph appears here

Take readings, or press Auto sweep to log a full set.

your readings

Theory

  • f = 1 / (2π R C) with equal R and C in both arms
  • At f the RC network passes 1/3 of the output with 0° phase shift
  • Barkhausen: loop gain A × β = 1, so A = 1 + Rf/R1 must be ≥ 3
  • Below 3 the oscillation dies; well above 3 it clips into a square-ish wave
  • Real circuits hold A at 3 with a lamp, diodes or a JFET

Worked out for your values

Oscillation frequency
1.592 kHz
Feedback fraction β at f
1/3
Loop gain A β
1.033
Output
Sine, slightly flat tops

Your result

Worked out from your readings and compared with theory.

C from f against 1/R

Take two or more readings at different R.

Sources of error

  • Mismatch between the two R or the two C shifts f
  • Gain set too high adds distortion and moves f slightly
  • 741 slew rate limits clean output above a few kHz at large amplitude