Lab / Virtual lab / Op-amps, timers and oscillators

Op-amp inverting and non-inverting amplifier

Measure the gain and see the output clip at the supply rails.

Op-amps, timers and oscillatorsSimulatedFull experiment write-up →

Circuit

Updates as you change values
−+VORf 10 kΩ0.5 VRin 10 kΩ

A 741 on ±12 V with Rin and Rf; a DC input from a potentiometer.

Controls

Changing any setting except input starts a new set of readings.

Meters

Output-0.5 V

Graph

0 readings

Your graph appears here

Take readings, or press Auto sweep to log a full set.

your readings

Theory

  • Inverting: AV = −Rf / Rin, input resistance = Rin
  • Non-inverting: AV = 1 + Rf / Rin, input resistance very high
  • Virtual short: the op-amp drives V− to equal V+
  • Output saturates near ±(VCC − 1.5 V) ≈ ±10.5 V on ±12 V
  • Bandwidth ≈ 1 MHz / (1 + Rf/Rin) for a 741

Worked out for your values

Gain AV
-1.00 (0.0 dB)
Output now
-500 mV
Largest input before clipping
10.5 V
Input resistance
10 kΩ
Small-signal bandwidth
500 kHz

Your result

Worked out from your readings and compared with theory.

Gain from the linear part

Take two or more readings where the output is not clipped.

Sources of error

  • Input offset voltage (up to 6 mV on a 741) shifts the output
  • Resistor tolerance sets the gain error
  • Saturation level depends on load and supply