Lab / AKTU / Analog and linear ICs / Experiment 7

RC phase-shift oscillator

Analog and linear ICsVirtual readings4 viva questionsRecord book ready
Open virtual bench
Aim

To design an RC phase-shift oscillator for a given frequency and measure its output frequency.

Apparatus
  • IC 741 (or BC547 for the transistor version)
  • Resistors
  • Capacitors 0.01 µF × 3
  • Dual supply ±12 V
  • CRO
Av ≈ 48

Theory

Three RC sections give 180° phase shift at f = 1/(2πRC√6), and the inverting amplifier gives another 180°, so the loop is in phase. The RC network attenuates by 1/29 at that frequency, so the amplifier gain must be at least 29 (Barkhausen criterion: loop gain ≥ 1, total phase 360°).

Circuit connections
  • Op-amp inverting amplifier with Rf ≥ 29R; its output feeds three RC sections in a ladder back to the inverting input

Procedure

Pre-lab check

4 questions · 75% to be ready
1State the Barkhausen criterion.
2Why three RC sections?
3Why is gain 29 needed?
4Where are RC oscillators used?

Try the readings before the lab

Calculated, not measured. In the lab, write down your own readings.
QuantityValue
f = 1 / (2πRC√6)999.6 Hz
Minimum gain29
Minimum Rf for this R188.5 kΩ

Precautions

  • Use matched capacitors.
  • Start with slightly more than the minimum gain to avoid a distorted output.

My readings

Type what you measured. It goes into your record book, and to My Garage when you are signed in.

S. No.QuantityValue
1
2
3
4
5
6

Check my readings

Put the value you set in the first column, then compare. Real parts have tolerance.

Open my record book
Result

Designed frequency ___ Hz, measured ___ Hz.

Everything above is free. The print-ready write-up comes with Maker.

Printed pages leave the observation table empty for your own readings.

Viva questions

Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.

1. State the Barkhausen criterion.
2. Why three RC sections?
3. Why is gain 29 needed?
4. Where are RC oscillators used?

Quick answers for your record and viva

What is the aim of the rc phase-shift oscillator experiment?

To design an RC phase-shift oscillator for a given frequency and measure its output frequency.

What apparatus is needed for rc phase-shift oscillator?

IC 741 (or BC547 for the transistor version), Resistors, Capacitors 0.01 µF × 3, Dual supply ±12 V, CRO.

What is the theory behind rc phase-shift oscillator?

Three RC sections give 180° phase shift at f = 1/(2πRC√6), and the inverting amplifier gives another 180°, so the loop is in phase. The RC network attenuates by 1/29 at that frequency, so the amplifier gain must be at least 29 (Barkhausen criterion: loop gain ≥ 1, total phase 360°).

What result should I get in rc phase-shift oscillator?

Designed frequency ___ Hz, measured ___ Hz.

What precautions should I take in rc phase-shift oscillator?

Use matched capacitors. Start with slightly more than the minimum gain to avoid a distorted output.

RC phase-shift oscillator: lab experiment, theory and viva