RDM6300 125 kHz RFID reader
Reads 125 kHz EM4100 cards and sends the ID over serial.
Radio125 kHz RFID
Typical rangeAbout 2 to 5 cm
InterfaceUART 9600 baud
Supply voltage5 V
WirelessReviewedMPN RDM6300Used in 4 projects
In short
What is the RDM6300 125 kHz RFID reader and what is it used for?
Reads 125 kHz EM4100 cards and sends the ID over serial. Makers use it for attendance with low-cost cards.
How it works
It powers a 125 kHz coil, and an EM4100 card in the field modulates it to send back its fixed ID.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | 125 kHz RFID |
| Typical range | About 2 to 5 cm |
| Interface | UART 9600 baud |
| Supply voltage | 5 V |
Pinout
VCC5 V
GNDGround
TXSerial out at 9600 baud
ANT1 ANT2Coil antenna
LEDCard-read indicator
How to use it
Read it with SoftwareSerial at 9600 baud. Each card sends a 14-byte frame: 0x02, ten ASCII hex characters of ID, two checksum characters and 0x03. Only TX needs wiring.
Applications
Attendance with low-cost cards
Builds that use it
Alternatives
- RC522 RFID reader13.56 MHz MIFARE cards over SPI
- PN532 NFC moduleNFC reader that can also talk to phones
Common questions
What is the RDM6300 125 kHz RFID reader used for?
In maker projects: attendance with low-cost cards.
How does the RDM6300 125 kHz RFID reader work?
It powers a 125 kHz coil, and an EM4100 card in the field modulates it to send back its fixed ID.
What voltage does the RDM6300 125 kHz RFID reader need?
5 V.
How do I connect the RDM6300 125 kHz RFID reader to an Arduino or ESP32?
UART 9600 baud. Pins: VCC (5 V), GND (Ground), TX (Serial out at 9600 baud), ANT1 ANT2 (Coil antenna), LED (Card-read indicator).
What can I use instead of the RDM6300 125 kHz RFID reader?
RC522 RFID reader and PN532 NFC module.
