PN532 NFC module
Reads and writes NFC tags and phones.
RadioNFC 13.56 MHz
Typical rangeAbout 5 cm
InterfaceI2C, SPI or UART
Supply voltage3.3 to 5 V
WirelessReviewedMPN PN532Used in 6 projects
In short
What is the PN532 NFC module and what is it used for?
Reads and writes NFC tags and phones. Makers use it for NFC tags, contactless projects.
How it works
An NXP PN532 NFC controller that drives a 13.56 MHz loop antenna.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | NFC 13.56 MHz |
| Typical range | About 5 cm |
| Interface | I2C, SPI or UART |
| Supply voltage | 3.3 to 5 V |
Pinout
VCC3.3 to 5 V
GNDGround
SDA SCLI2C
SCK MISO MOSI SSSPI
TXD RXDHSU serial
IRQ RSTOInterrupt and reset
SwitchesPick I2C, SPI or HSU as printed on the board
How to use it
Set the two switches for the interface, then use the Adafruit_PN532 or Seeed PN532 library. It reads MIFARE Classic, Ultralight and NTAG tags, and can talk to phones in some modes.
Applications
NFC tagscontactless projects
Builds that use it
Alternatives
- RC522 RFID readerCheaper MIFARE reader over SPI
- RDM6300 125 kHz RFID reader125 kHz cards
Common questions
What is the PN532 NFC module used for?
In maker projects: NFC tags, contactless projects.
How does the PN532 NFC module work?
An NXP PN532 NFC controller that drives a 13.56 MHz loop antenna.
What voltage does the PN532 NFC module need?
3.3 to 5 V.
How do I connect the PN532 NFC module to an Arduino or ESP32?
I2C, SPI or UART. Pins: VCC (3.3 to 5 V), GND (Ground), SDA SCL (I2C), SCK MISO MOSI SS (SPI), TXD RXD (HSU serial), IRQ RSTO (Interrupt and reset).
What can I use instead of the PN532 NFC module?
RC522 RFID reader and RDM6300 125 kHz RFID reader.
