Components / Sensors / PMS5003 particulate matter sensor

PMS5003 particulate matter sensor

Laser dust sensor that counts PM1.0, PM2.5 and PM10.

MeasuresPM1.0, PM2.5, PM10 mass concentration
Range0 to 500 µg/m³ effective
InterfaceUART 9600 baud, 3.3 V logic
Supply voltage5 V, about 100 mA
SensorsReviewedMPN PMS5003Used in 9 projects
PMS5003
In short

What is the PMS5003 particulate matter sensor and what is it used for?

Laser dust sensor that counts PM1.0, PM2.5 and PM10. Makers use it for air pollution monitors.

How it works

A fan draws air through a laser beam, and a detector counts and sizes particles from the light they scatter.

Key specifications

Sensor specValue
MeasuresPM1.0, PM2.5, PM10 mass concentration
Range0 to 500 µg/m³ effective
InterfaceUART 9600 baud, 3.3 V logic
Supply voltage5 V, about 100 mA

Pinout

VCC5 V
GNDGround
SETSleep when LOW
RXUART in (3.3 V)
TXUART out, 9600 baud
RESETReset when LOW
NCNot connected

How to use it

Use a breakout for the small 1.25 mm connector and read with the PMS library. The fan needs 30 seconds to give stable readings after waking. High humidity makes readings rise because droplets are counted as particles.

Applications

Alternatives

Buy at

Common questions

What is the PMS5003 particulate matter sensor used for?

In maker projects: air pollution monitors.

How does the PMS5003 particulate matter sensor work?

A fan draws air through a laser beam, and a detector counts and sizes particles from the light they scatter.

What voltage does the PMS5003 particulate matter sensor need?

5 V, about 100 mA.

How do I connect the PMS5003 particulate matter sensor to an Arduino or ESP32?

UART 9600 baud, 3.3 V logic. Pins: VCC (5 V), GND (Ground), SET (Sleep when LOW), RX (UART in (3.3 V)), TX (UART out, 9600 baud), RESET (Reset when LOW).

What can I use instead of the PMS5003 particulate matter sensor?

SDS011 particulate matter sensor and GP2Y1014AU dust sensor.