Components / Sensors / GP2Y1014AU dust sensor

GP2Y1014AU dust sensor

Optical dust sensor with an analog output. Needs a resistor and capacitor.

MeasuresDust density (relative)
InterfaceAnalog with a pulsed LED
Supply voltage5 V
SensorsReviewedMPN GP2Y1014AU0FUsed in 2 projects
GP2Y1014
In short

What is the GP2Y1014AU dust sensor and what is it used for?

Optical dust sensor with an analog output. Needs a resistor and capacitor. Makers use it for simple dust trend.

How it works

An IR LED lights the air in a hole through the sensor and a phototransistor sees light scattered by dust.

Key specifications

Sensor specValue
MeasuresDust density (relative)
InterfaceAnalog with a pulsed LED
Supply voltage5 V

Pinout

V-LEDLED supply through 150 Ω, with 220 µF to ground
LED-GNDLED ground
LEDLED control, active LOW
S-GNDSignal ground
VoAnalog output
Vcc5 V

How to use it

Pulse the LED low for 0.32 ms every 10 ms and read Vo 0.28 ms after turning it on. It gives a relative dust density; treat it as a trend rather than calibrated PM2.5.

Applications

Alternatives

Buy at

Common questions

What is the GP2Y1014AU dust sensor used for?

In maker projects: simple dust trend.

How does the GP2Y1014AU dust sensor work?

An IR LED lights the air in a hole through the sensor and a phototransistor sees light scattered by dust.

What voltage does the GP2Y1014AU dust sensor need?

5 V.

How do I connect the GP2Y1014AU dust sensor to an Arduino or ESP32?

Analog with a pulsed LED. Pins: V-LED (LED supply through 150 Ω, with 220 µF to ground), LED-GND (LED ground), LED (LED control, active LOW), S-GND (Signal ground), Vo (Analog output), Vcc (5 V).

What can I use instead of the GP2Y1014AU dust sensor?

PMS5003 particulate matter sensor.