Components / Sensors / GPS module NEO-6M

GPS module NEO-6M

GPS receiver with a ceramic antenna that sends NMEA sentences over serial.

MeasuresPosition, time, speed
AccuracyAbout 2.5 m in open sky
InterfaceUART, 9600 baud default
Supply voltage3.3 to 5 V (module)
SensorsReviewedMPN NEO-6M (GY-GPS6MV2)Used in 21 projects
GPS
In short

What is the GPS module NEO-6M and what is it used for?

GPS receiver with a ceramic antenna that sends NMEA sentences over serial. Makers use it for trackers, clocks, logging rides.

How it works

The receiver measures timing signals from several satellites and calculates its position from the differences.

Key specifications

Sensor specValue
MeasuresPosition, time, speed
AccuracyAbout 2.5 m in open sky
InterfaceUART, 9600 baud default
Supply voltage3.3 to 5 V (module)
Operating temperature−40 to 85 °C
Watch out forNeeds open sky; the first fix can take a few minutes

Pinout

VCC3.3 to 5 V
RXReceives data from your board (3.3 V logic)
TXSends NMEA sentences at 9600 baud
GNDGround
PPSOne pulse per second (on some boards)

How to use it

Connect TX to your board's RX (Serial2 on an ESP32) and parse the NMEA sentences with TinyGPSPlus. Test outdoors or by a window: the first fix can take several minutes. The small battery on the board keeps data for faster restarts.

Applications

Alternatives

Buy at

Common questions

What is the GPS module NEO-6M used for?

In maker projects: trackers, clocks, logging rides.

How does the GPS module NEO-6M work?

The receiver measures timing signals from several satellites and calculates its position from the differences.

What voltage does the GPS module NEO-6M need?

3.3 to 5 V (module).

How do I connect the GPS module NEO-6M to an Arduino or ESP32?

UART, 9600 baud default. Pins: VCC (3.3 to 5 V), RX (Receives data from your board (3.3 V logic)), TX (Sends NMEA sentences at 9600 baud), GND (Ground), PPS (One pulse per second (on some boards)).

What can I use instead of the GPS module NEO-6M?

NEO-M8N GPS module and ATGM336H GPS module.