Projects / Ideas / ADC input clamp with a 15 V zener

ADC input clamp with a 15 V zener

BeginnerTest & MeasurementIdeaReviewed
In short

How do you build an ADC input clamp with a 15 V zener?

Divide down a 12 to 15 V signal for a board input and clamp it with a zener so a spike cannot reach the pin. You need Arduino Nano, Zener diode 15 V (1N4744A), Resistor 10 kΩ, Resistor 33 kΩ, Resistor 1 kΩ, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.

Level
Beginner
Time
About 120 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Protect an analogue input.

How to build it

  1. Work out the divider
  2. Add the series resistor
  3. Add a clamp at the pin
  4. Test with a battery
  5. Measure the clamp voltage

Related projects

Common questions

What parts do I need for the ADC input clamp with a 15 V zener?

Arduino Nano, Zener diode 15 V (1N4744A), Resistor 10 kΩ, Resistor 33 kΩ, Resistor 1 kΩ, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.

How long does the ADC input clamp with a 15 V zener take to build?

About 120 minutes for a beginner maker.